Black300 and 48V inverters |
|
1 2
|
28.06.2009 18:59
Erzwind
|
Re: Black300 and 48V inverters
Hi George,
2 Stück UWT250 parallel passen natürlich besser zu einen Black 300. Wie wir schon oft gelesen haben, bringt der Black 300 schon mal 500 W! und so mancher Windmaster 500 ist wegen Überlast vom Netz gegangen. Ich würde dir für deine zwei UWT250 einen Black 300-24V empfehlen, da die max. Eingangsspannung der UWT 60V nicht überschreiten darf. Bei einen Black 300-48V in Verbindung mit einen Mastervolt 500, liegt der Arbeitsbereich zwischen 40V und 100V DC. Wie viele Arbeitspunkte kann man bei dem UWT einstellen? Mit dieser Info könnte ich versuchen, eine Leistungskurve für die UWT mit Black 300-24V zu erstellen.
Grüße von Erzwind
|
|
|
03.07.2009 09:51
George
|
Re: Black300 and 48V inverters
Dear Erzwind,
It took me some to gather the data you asked for, but now I have the info. I can configure two parameters in the UWT250 : starting voltage, and the steepness of the line in V/A. The starting voltage can be set between 20.3 and 34.3 V. The steepness can be set between 3.5 and 6.0 V/A. In the graph you can see the voltage against netpower.
I hope the 24 V type is suitable. I am realy looking forward to the "Leistungskurve" of the black 300 connected to these inverters.
I am still wondering if the 48V Type connected to my inversters really will go up to 100V Dc. The virtual resistance of my inverters will raise the current and probably keep the voltage at normal levels. Higher voltage has tha advance that the currents stay a bit limited. This means less risk on heat development etc.
Regards George
|
|
|
|
1 2
|